Computer/Windows/Office/ Discussion Blog

July 24, 2017

How do i to do if XP can not sandby?

Filed under: computer knowledge,windows xp — admin @ 6:47 pm

Q: I’m using the XP system, but the standby options are not available now. Only the restart and shutdown options are available, whether it’s the GHOST or the reinstall disk. Excuse me, master Dong, what’s the problem?
Answer: there are several possibilities for this problem:
First, device drivers (such as CD-ROM) are in use and should be removed from the drive.
Second, running a software or a driver that has compatibility issues. After you install the new operating system, don’t install any other software and drivers, and don’t do any “optimization”. Check to see if you can get into the standby mode. If it is a driver problem, please upgrade to the latest version.
Third, there is a problem with the IDE controller driver. After you install the operating system, install the motherboard driver immediately. This driver can be found on the CD attached to the motherboard. You can also try installing the latest motherboard drivers.
Fourth, the hard disk itself has problems. First, run ScanDisk to check the hard disk and run the antivirus software check system. Next, unplug the power line, open the case, and remove all the hard disks, drives, and even floppy drives from the main disk. If the problem is not solved, let the hard disk and drive drive use separate data lines. Check whether the hard disk and drive jumper are correct. Make sure the data line is not damaged and closely connected.
Finally, if the hard disk or CD-ROM models may be relatively early, can not support the advanced standby mode, this can put CMOS in the “Power Management Setup” in “ACPI Function” is set to “Enable”, “ACPI Suspend Type” is set to “S3 (STR)”.

July 4, 2017

XP system can not be installed, what should I do?

Filed under: windows xp — admin @ 6:01 pm

Fault phenomenon: friend machine because of the Internet computer virus, can not enter the system, please me to reinstall the system, I took the tool disc, preferred in the BIOS selection CD-ROM started to use DM to partition hard drive, then back into the DVD system, with WinXP professional edition, CD run to the Microsoft agreement, press the F8 key reaction slowly, that comes with the WinXP partition to delete the C drive partition, no response, crashed. That is a hard problem, restart, but this crash put off some, such as format crash. After the restart, again with the DM partition after the start in the D drive with rapid format, using the Windows XP disk to copy the file 53% crash.

Troubleshooting: this problem is mainly XP system cannot be installed, think carefully, suddenly think of it is not DVD CD-ROM problem, because DVD CD-ROM used for a long time, reading quality decreased, read data can cause incomplete system can not be installed. Immediately took home the DVD recorder installed in your computer, friends, re partition into the WinXP installation disk, installed above the location, without any problems, until the installation is complete, without any exception, everything is normal.

Powered by WordPress