Computer/Windows/Office/ Discussion Blog

June 30, 2017

CMOS setting wrong

Filed under: computer knowledge — admin @ 7:04 pm
Fault phenomenon: Power Boot self-test appeared so error: “CMOS setting wrong Press F1, to setup, Press F2 to load default setting” and then wait for your choice, if you enter the CMOS setup set whether or not, exit the CMOS setup interface, restart the computer after self-test will no longer appear the above error can be normally started running Windows XP system. If you press F2 directly in the above prompt, you can also start running the Windows XP system. However, regardless of the choice of F1 or F2 according to the normal start running Windows XP system, the computer will automatically run about 5 minutes after the black, even press the reset button on the mainframe box (reset Jian Zhengchang), can’t restart the computer (the computer or in the black screen), this must be cut off and then re energized, computer in order to restart.
Fault analysis: the message of “CMOS setting wrong”, that is some parameter value of the CMOS option is set incorrectly, then directly into the CMOS settings interface, modify that may cause some of the options of the parameter error value, after repeated modifications, the fault is still. Could it be that the BIOS program associated with CMOS is out of order? Download the model board on the Internet, and refresh the latest BIOS program. The refresh process has been successfully completed, and then restart the computer, the failure is still. Www.sq120.com recommended articles
Troubleshooting: it seems that the motherboard itself is a circuit problem. On the motherboard may cause this fault in electronic components, only the motherboard CMOS battery and BIOS chip is easy to change, but the BIOS chip refresh is very smooth, so first ruled out the possibility of BIOS chip failure. So choose to replace the CMOS battery, after the replacement, restart the computer, troubleshooting. There is no such fault again.
Fault phenomenon: Power Boot self-test appeared so error: “CMOS setting wrong Press F1, to setup, Press F2 to load default setting” and then wait for your choice, if you enter the CMOS setup set whether or not, exit the CMOS setup interface, restart the computer after self-test will no longer appear the above error can be normally started running Windows XP system. If you press F2 directly in the above prompt, you can also start running the Windows XP system. However, regardless of the choice of F1 or F2 according to the normal start running Windows XP system, the computer will automatically run about 5 minutes after the black, even press the reset button on the mainframe box (reset Jian Zhengchang), can’t restart the computer (the computer or in the black screen), this must be cut off and then re energized, computer in order to restart.
Fault analysis: the message of “CMOS setting wrong”, that is some parameter value of the CMOS option is set incorrectly, then directly into the CMOS settings interface, modify that may cause some of the options of the parameter error value, after repeated modifications, the fault is still. Could it be that the BIOS program associated with CMOS is out of order? Download the model board on the Internet, and refresh the latest BIOS program. The refresh process has been successfully completed, and then restart the computer, the failure is still. Www.sq120.com recommended articles
Troubleshooting: it seems that the motherboard itself is a circuit problem. On the motherboard may cause this fault in electronic components, only the motherboard CMOS battery and BIOS chip is easy to change, but the BIOS chip refresh is very smooth, so first ruled out the possibility of BIOS chip failure. So choose to replace the CMOS battery, after the replacement, restart the computer, troubleshooting. There is no such fault again.

No Comments

No comments yet.

RSS feed for comments on this post.

Sorry, the comment form is closed at this time.

Powered by WordPress